The 80 polymer frame Diaries

Whatsoever portion is not Performing…consider all of it with inventory OEM sections.  Sometimes aftermarket slides and triggers have too limited tolerances to operate inside a P80.  Thus far the Brownells and Gray Ghost (somewhat tight) have worked in my builds.  I’ve listened to ZEV slides is likely to be also limited.

We pleasure ourselves on palms-on testing and serious-globe practical experience with all merchandise we advocate. Additional, we believe in objectivity and approaching all articles without having bias – our couple advertisers hardly ever affect our reviews or recommendations.

Eric, with all owing respect, I believe the LWD kit isn't a good suggestion for these, and would strongly propose Glock sections. I've also crafted 3 of these.

Once you clip the tabs make use of a "fret cutter" obtainable on Amazon, this may Slash them properly flush. Also having a problem Along with the cause not resetting on a forty three and 26, the tip around the result in bar hitting the frame might do the trick. The 21 has an abundance of clearance between the cause bar and frame and resets perfect anytime.

Do you believe they will at any time try this with other polymer pistols? I am not a large fan of DAO triggers/striker fired. But i do similar to this strategy.

Dilemma, really should I obtained a inventory Glock or build a poly80? What’s the higher choice? I do wanna enhance the areas inside a afterwards time Once i do purchase a stock Glock but isn’t that just a squander of money and time? Help me be sure to! Thank you.

The P80 frame is an ideal technique to build a one hundred% Glock®-compatible handgun with factory or aftermarket pieces at a lower Expense. Created from a custom made substantial-energy polymer, these frames choose Glock®’s OEM style and design and insert some upgrades.

Now I seize the sandpaper…I start off slightly rougher and graduate to one thing pretty substantial grit (much less rough).  You can also wrap it all over anything tough and straight in the event you don’t rely on oneself.

Is the size with the grip the very same as to the Glock 19 or can it be a bit extended? The 19 is slightly small for my hand but i want a 4" barrel so I'm able to insert a Compensater, without having emotion like I'm holding a Dirty Hairy revolver, over a G17. Or would potentially including a Magwell flair support with this?

Thank you for making these how tos. I normally return to you each time I assemble anything at all. Ar’s and now intending to consider 1 of these I think. Thank you greatly

In case you are employing a used slide It might get more info be already installed. I used to be considering a custom slide along with the installation in the channel liner was an option.

This was tricky the primary couple of occasions since You must wiggle the slide halt lever…and every thing is actually tight.  I recommend employing a punch being a slave pin so everything is by now oriented.

I would counsel carrying out it solely by hand…or beginning it off using a Dremel and a grinding attachment.

In case the slide feels tough…again it’s the barrel block area.  Ensure it’s smooth and you can operate something along the bottom and make sure practically nothing snags.